| Step | | Procedure & Parts & Tools |
| 1 |
|
SEE RUNTIME CHART SHOWN IN THIS STEP. THIS CHART SHOWS EXPECTED RUN TIME FOR THE SIZE OF THE BATTERIES FOR DIFFERENT APPLICATIONS. IF YOUR RUNTIME MATCHES THE CHART, YOUR BATTERIES ARE PROBABLY GOOD.
|
| 2 |
|
CONNECT GRAY CHARGER PLUG ON BATTERY CHARGER TO CHARGER PLUG ON THE BACK OF THE MACHINE. CHARGE YOUR BATTERIES OVER NIGHT OR 8 HOURS.
|
| 3 |
|
VISUALLY INSPECT CHARGER STATUS. IF FLASHING GREEN LIGHT, CHARGER IS CHARGING. IF SOLID GREEN LIGHT, CHARGING IS COMPLETE. IF RED LIGHT IS ON, THE CHARGER IS NOT WORKING CORRECTLY. IF STATUS IS OKAY, CONTINUE TO STEP 4. IF CHARGER STATUS IS NOT OKAY, FIX CHARGER AND START BATTERY TEST.
|
| 4 |
|
LOCATE THE MACHINE TOOL THAT WAS ATTACHED TO THE KEY RING OF YOUR MACHINE. THIS TOOL WILL BE USED TO OPEN THE MACHINE. IF YOU DO NOT HAVE THIS TOOL, YOU CAN USE A LONG FLAT TIP SCREWDRIVER.
|
| 5 |
|
LOCATE THE LABEL ON THE LEFT SIDE OF MACHINE (STANDING IN OPERATOR POSITION). FOLLOW THE DIRECTIONS ON THE LABEL TO OPEN THE MACHINE.
|
| 6 |
|
FOLLOWING THE DIRECTIONS ON THE LABEL, INSERT THE MACHINE TOOL INTO THE MACHINE.
|
| 7 |
|
PUT THE RED PROBE ON THE POSITIVE CABLE AND THE BLACK PROBE ON THE NEGATIVE CABLE. VOLT METER SHOULD READ APPROXIMATELY 24 VOLTS. IF BATTERIES ARE OKAY, CLOSE THE MACHINE.
| Volt meter (True RMS capable) |
&Width=100)
|
|